Hi, I am thinking of getting 'SRF05 Ultrasonic Sonar Sensor' and use it to display the distance measured onto LCD..
The sensor itself is easy to use as it performs ranging using only a single pin (I assume it means that only 1 pin is connected to the PIC16F877 which is RB0..
What the hard part is is understanding the code which is for LCD03 (**broken link removed**)
and convert it to a code that I can use for parallel LCD.
The code for 'SRF05 Ultrasonic Sonar Sensor' is https://www.robot-electronics.co.uk/files/srf05_lcd03.c (written in HITECH PIC16).
What I need is very simple. No need to display all the fancy stuff.. It just need to display the measurements in cm.. I assume that means that alot of code can be strip off as it is not needed..
Advice is very much needed and appriciated..
Thanks..
The sensor itself is easy to use as it performs ranging using only a single pin (I assume it means that only 1 pin is connected to the PIC16F877 which is RB0..
What the hard part is is understanding the code which is for LCD03 (**broken link removed**)
and convert it to a code that I can use for parallel LCD.
The code for 'SRF05 Ultrasonic Sonar Sensor' is https://www.robot-electronics.co.uk/files/srf05_lcd03.c (written in HITECH PIC16).
What I need is very simple. No need to display all the fancy stuff.. It just need to display the measurements in cm.. I assume that means that alot of code can be strip off as it is not needed..
Advice is very much needed and appriciated..
Thanks..