Application:
I have a RF receiver attached on a pole that is connected to a computer inside a trailer. The RF rec has a 4 position switch (manual) that I want to convert to an electronic switch that will be activated inside the computer so that the the computer can rotate (electronicly) thru the 4 posotions on the switch in the RF receiver.
I'm going to run a wire (from an existing cable) from each position on the the switch in the RF amp down to the computer and I need to attach the electronic switch to these four wires to rotate the switching.
So basicly I need the circuit to provide the electronic switching from the computer.
Any help in this regard would be greatly appreciated.
Thanks
Dolphin
I have a RF receiver attached on a pole that is connected to a computer inside a trailer. The RF rec has a 4 position switch (manual) that I want to convert to an electronic switch that will be activated inside the computer so that the the computer can rotate (electronicly) thru the 4 posotions on the switch in the RF receiver.
I'm going to run a wire (from an existing cable) from each position on the the switch in the RF amp down to the computer and I need to attach the electronic switch to these four wires to rotate the switching.
So basicly I need the circuit to provide the electronic switching from the computer.
Any help in this regard would be greatly appreciated.
Thanks
Dolphin