Hi, were doing a project which aims to control a Ref Compressor using PWM. From our knowledge the motor is single phase. the PWM comes from our PIC where its input is obtained from our own made thermostat and we aim to control it by varying the frequency of the voltage that is entering the Motor. After the PIC we plan to connect its output to an INVERTER.
From our knowledge the inverter outputs a square wave.
Question.
1. Is the square wave good enough to be our input to the motor?
2. is an INVERTER the best way to go since we want to revert back to 220V after the our PIC output?
any useful suggestion is appreciated Thank You
From our knowledge the inverter outputs a square wave.
Question.
1. Is the square wave good enough to be our input to the motor?
2. is an INVERTER the best way to go since we want to revert back to 220V after the our PIC output?
any useful suggestion is appreciated Thank You