Could anyone please help me. I'm using AWR design software and I can't find some of the components. These are an MSUB a VAR a VIA and a V_DC. The components in question are from the circuit on page 6 of this document https://www.avagotech.com/pc/downloadDocument.do?id=4531
Ant help would be greatly appreciated.
Could anyone please help me. I'm using AWR design software and I can't find some of the components. These are an MSUB a VAR a VIA and a V_DC. The components in question are from the circuit on page 6 of this document https://www.avagotech.com/pc/downloadDocument.do?id=4531
Ant help would be greatly appreciated.
Are you trying to pull our collective legs? If you cannot figure it out, you have no bisness building this amplifier. FYI: MSUB is part of the layout, I am not familiar with RF layout, so can't tell yu what it is. VAR is the mosfet transistor that this amplifier is all about. VIA is a plated thru hole in the substrate, so the two inductors are on opposite sides of the substrate. V_DC is a power supply, voltage = VGS of VAR.
I think you are trying to do a microwave board design without having a clue. MSUB is giving you the properties of the PC board material and other critical parameters for computing the imeadance of the striplines (MLIN), Step Attenuators(MSTEP) and tees (MTEEO).
VIA is a hole through the board.
V_DC is a DC voltage source.
VAR, with a Vgs of 0.55V, is the active device, an ATF 33143 PHEMT.
Impeadance matching is fun stuff. Time to break out the 'ole Smith Chart!
Could anyone please help me. I'm using AWR design software and I can't find some of the components. These are an MSUB a VAR a VIA and a V_DC. The components in question are from the circuit on page 6 of this document https://www.avagotech.com/pc/downloadDocument.do?id=4531
Ant help would be greatly appreciated.