Centre tap on Transformer

A

Andrew Leigh

Member

• Jul 28, 2008

• #1

Hi,

is it possible to create a virtual 0V centre tap with an existing prewound transformer with only two leads coming out? I would like to take a 9V 10A out put and to turn it into 2 x 4,5V.


Cheers
Andrew

 

Nigel Goodwin

Super Moderator

Most Helpful Member

• Jul 28, 2008

• #2

Basically no, although depending on EXACTLY why you need to do it, there may be other solutions?.

 

Sceadwian

Banned

• Jul 28, 2008

• #3

A voltage divider between the two taps fed into a simple voltage follower? As Nigel said though it really depends on exactly what you're going to do with it.

 

Hero999

Banned

• Jul 28, 2008

• #4

What's the maximum current through the 0V line?

If it's fairly small then a couple of resistors would do the trick.

If you need more current then an autotransformer would do it but it's a fairly bulky solution and you'd wind it yourself.

Do you have a rectifier and filter capacitor on the output?

If so and active virtual earth circuit can be used.

https://www.electro-tech-online.com/threads/5v-supply-from-two-7805s.39621/

 

A

Andrew Leigh

Member

• Jul 29, 2008

• #5

Hi,

thanks for the input. The current is 10A so it looks like the simplest is to get a new transformer wound.


Cheers
Andrew

 

Hero999

Banned

• Jul 29, 2008

• #6

I know the current is 10A but that wasn't my question, what's the 0V line current?

For example, if the current through the phase is 10A and the current through the anti-phase is 9A, the current through the 0V line will only be 1A.