car remote

[cutter]

I would like to copy a car remote only from the wave MHz which I have is this possible?

 

[kinjalgp]

Could you be a bit more clear?

 

[cutter]

I have to sweep(annihilate) the frequence of one alarm car remote . I have to keep(preserve) the frequence mhz and if possible that only from the frequency to make one the other car remote

 

[kinjalgp]

If I am not mistaken, modern remote car locks have digital ID codes and each one of them have unique ID and all these run at same frequency. The TX and RX are matched ones and the RX responds to its TX only. This technique makes very less chances of interference. If you change the frequency, i don't think it will work for other car.

 

[bogdanfirst]

from what i understand you want to jam the other remote?
generate a frequency just like the one from the remode but without the cone or with a wrong code?

 

[hsvgtsr1]

it is impossible these days as the remotes have a frequency but also have a unique identifier code and without this code you can not jam it.

 

[hsvgtsr1]

the way you ask it this is like you want to break into a car.

 

[Sebi]

I just heard about: take a simply receiver on remote controller frequency, and connect the output to laptop microphone input. When the remote controller work, You can make recording the bitstream.With wawe editor can see the timing and combinations.This method doesn't work with hopping-code systems.