Mr.K
New Member
I working on a keypad controlled light dimmer and need some assistance with the coding for it. Here's what I want to do
When power is first turned on press “*” and enter a four digit default code; such as, “0000”.
-The light will begin to function.
- To change the code press “#” input the old code followed with a new four digit code sequence.
- New code sequence is accepted and must be used to allow the light to
function.
- Increasing brightness of the light will be controlled by pressing “2”.
-Decreasing brightness of the light will be controlled by pressing “8”
- After 30 seconds the user can not change the brightness with the “2” or “8” key. The selected code sequence must be re-entered.
- At anytime in the future the selected four digit sequence can be re-programmed following step # 3
-Thanks!
When power is first turned on press “*” and enter a four digit default code; such as, “0000”.
-The light will begin to function.
- To change the code press “#” input the old code followed with a new four digit code sequence.
- New code sequence is accepted and must be used to allow the light to
function.
- Increasing brightness of the light will be controlled by pressing “2”.
-Decreasing brightness of the light will be controlled by pressing “8”
- After 30 seconds the user can not change the brightness with the “2” or “8” key. The selected code sequence must be re-entered.
- At anytime in the future the selected four digit sequence can be re-programmed following step # 3
-Thanks!
Last edited: