UTMonkey
Member
Hi All,
I remember reading a thread a few weeks ago where someone submitted an image of a breadboard demonstrating some feature.
What caught my attention, was that the designer had included a "daughter" circuit board to the breadboard which looked like its purpose was to provide a regulated 5 volts aligned perfectly to the positive and negative rails of the breadboard circuit.
I remember thinking thats a clever idea, but I didnt bookmark it and now I can't find it.
Does this ring any bells?
Thanks
Mark
I remember reading a thread a few weeks ago where someone submitted an image of a breadboard demonstrating some feature.
What caught my attention, was that the designer had included a "daughter" circuit board to the breadboard which looked like its purpose was to provide a regulated 5 volts aligned perfectly to the positive and negative rails of the breadboard circuit.
I remember thinking thats a clever idea, but I didnt bookmark it and now I can't find it.
Does this ring any bells?
Thanks
Mark