Hello,
From looking at the datasheet I see that PB5 is an I/O pin with the following alternative functions:
RESET: Reset Pin
dW:
debugWIRE I/O
ADC0:
ADC Input Channel 0
PCINT5in Change Interrupt, Source 5
Usually the Reset pin is connected to Vcc through a 10k resistor.
My application doesn't need a reset function, Can I just ignore it and Use it as an I/O pin ?
From looking at the datasheet I see that PB5 is an I/O pin with the following alternative functions:
RESET: Reset Pin
dW:
debugWIRE I/O
ADC0:
ADC Input Channel 0
PCINT5in Change Interrupt, Source 5
Usually the Reset pin is connected to Vcc through a 10k resistor.
My application doesn't need a reset function, Can I just ignore it and Use it as an I/O pin ?