2camjohn
Member
I have just started using an ICD2 programmer.
I have followed the tutorials and got to the point where everything is beng detected by MPLAB including a PIC16f648a that is in the development board.
MPLAB is setup to use ICD2 but with debugging disabled.
My problem is, I cant get it to program a hex file.
I have gone to file->import-> selected the location of my (known to be working) hex file, so that it shows up in the window and on the project (under other files).
When I click program, it reports a success but just programs a blank file to the microcontroller. The microcontroller shows no life, and reading back the program gives all 1s.
It passes the verify tests also, which indicates to me that its not trying to program the file I imported, but it is successfully programming a blank file.
If anyone can offer any help on this, I would really appreciate it.
John
I have followed the tutorials and got to the point where everything is beng detected by MPLAB including a PIC16f648a that is in the development board.
MPLAB is setup to use ICD2 but with debugging disabled.
My problem is, I cant get it to program a hex file.
I have gone to file->import-> selected the location of my (known to be working) hex file, so that it shows up in the window and on the project (under other files).
When I click program, it reports a success but just programs a blank file to the microcontroller. The microcontroller shows no life, and reading back the program gives all 1s.
It passes the verify tests also, which indicates to me that its not trying to program the file I imported, but it is successfully programming a blank file.
If anyone can offer any help on this, I would really appreciate it.
John