Is there a minimum time before you can issue a convert command ?
I have the convert command running in an endless loop and each time it displays a few of the scratchpad registers on a glcd. I notice that it works once, and only once. (i.e if i take the convert command out of the loop and just run it once and then display, it works, but if i run the command again, i get 0xff.
If needed I can post my code, but im just curious if there is min time before each command. I did check the datasheet and i couldnt see anything in there.
I have the convert command running in an endless loop and each time it displays a few of the scratchpad registers on a glcd. I notice that it works once, and only once. (i.e if i take the convert command out of the loop and just run it once and then display, it works, but if i run the command again, i get 0xff.
If needed I can post my code, but im just curious if there is min time before each command. I did check the datasheet and i couldnt see anything in there.