SmokedCircuit64
New Member
I picked up some things from the "Shack". I have to modify the heat sink they had. It is way larger than the MOSFET we are using. And I have to use a screw and washer to secure it to the heat sink
The Power supply I'm using is 13.8 V and 3 amps.. As listed on the label. I measured 14.0 V from my multimeter. I tried to take a amp reading and it was jumping all over the place, like from 9.1 down to .4.. Not sure what that was about.
I have two options for laying it all out.. I picked up a bread board and jumpers.. and a circuit board.
I also attached some of the info for the coil I need to build. The Chinese coil is 12v and .42 amps I don't think I can get it apart with out totally destroying it LOL
The Power supply I'm using is 13.8 V and 3 amps.. As listed on the label. I measured 14.0 V from my multimeter. I tried to take a amp reading and it was jumping all over the place, like from 9.1 down to .4.. Not sure what that was about.
I have two options for laying it all out.. I picked up a bread board and jumpers.. and a circuit board.
I also attached some of the info for the coil I need to build. The Chinese coil is 12v and .42 amps I don't think I can get it apart with out totally destroying it LOL