Hiya!
I need to put together a simple light-flasher circuit to simulate 'sparking/arcing' wires. Problem I have is space constraints - I have to fit all the circuitry, power-supply and switch into two volumes: a 60mmx3mm disc and a 10mmx10mm cube.
Basically it has to fit into the model and base below and is to represent trailing wires once an arm is ripped off. The lights would hang on wires out the arm socket.
**broken link removed**
I really don't know what options are out there, so help in describing what I could do to solve this problem would be very-much appreciated! There must be pre-existing solutions already available...
Thanks for your help in advance!
Regards,
Andrew.
P.S. Apologies for the newbie question - my last analog electronics experience was decades ago.
I need to put together a simple light-flasher circuit to simulate 'sparking/arcing' wires. Problem I have is space constraints - I have to fit all the circuitry, power-supply and switch into two volumes: a 60mmx3mm disc and a 10mmx10mm cube.
Basically it has to fit into the model and base below and is to represent trailing wires once an arm is ripped off. The lights would hang on wires out the arm socket.
**broken link removed**
I really don't know what options are out there, so help in describing what I could do to solve this problem would be very-much appreciated! There must be pre-existing solutions already available...
Thanks for your help in advance!
Regards,
Andrew.
P.S. Apologies for the newbie question - my last analog electronics experience was decades ago.