I have a keypad that is a membrane type keypad and the Flex-Tail or
part of the membrane that has the external connections has been cut. Does anybody have any suggestions for repair. Most of the connections
feed thru the upper layer of the membrane to a lower layer and don't terminate anywhere I can get to to solder to them unless I can get thru the outer protective layer. Any help would be appreciated.
part of the membrane that has the external connections has been cut. Does anybody have any suggestions for repair. Most of the connections
feed thru the upper layer of the membrane to a lower layer and don't terminate anywhere I can get to to solder to them unless I can get thru the outer protective layer. Any help would be appreciated.