I have measured the current now in the circuit from post #38 with a scope across
a 1 Ohm resistor after the load resistor.
With no base resistor for the darlington pair i get a maximum current of 300mA
from the transistors to the load.
Since i need 3 times that to get to 1 amp, i will insert smaller transistors again
inbetween.
a 1 Ohm resistor after the load resistor.
With no base resistor for the darlington pair i get a maximum current of 300mA
from the transistors to the load.
Since i need 3 times that to get to 1 amp, i will insert smaller transistors again
inbetween.