the reset pin on the 8266 must be pulled low (<.8v) to bring it out of deep sleep.
I'm trying to make a battery operated water sensor. When there is water between the 2
leads the resistance is around 600K - 1.5M.
Although I'm an electrical engineer I cant say I understand transistors...
Is there a way with a transistor circuit to pull that reset line low WHEN
the resistance on the water leads goes from OPEN to 600K-1.5M ?
Or any other suggestions on a method to accomplish this, preferable where
it doesn't use power when no water is present : )
Thanks much for any help
tim
O