Hi all,
I've been following a schematic where two LED's blink. I was picking the parts carefully, making sure of right power and it doesn't work. In fact, it's working two-three times both LED's blink but that's it. An error appears saying that Multisim will try to fix that error but cannot. See the schematic below. There is one that I followed while the other one is the schematic from Multisim.
What might be the problem? It's a very simple scheme, but maybe there's an error in Multisim? Thanks.
Components values
R1 - 470 Ohm
R2 - 470 Ohm
R3 - 3.9 kOhm
R4 – 3.9 kOhm
P1 - 50 kOhm
C1 – 47 μF / 16V
C2 - 47 μF / 16V
T1 - BC 547 B
T2 - BC 547 B
D1 - LED Standard , 5 mm , red
D2 - LED Standard , 5 mm , red
I've been following a schematic where two LED's blink. I was picking the parts carefully, making sure of right power and it doesn't work. In fact, it's working two-three times both LED's blink but that's it. An error appears saying that Multisim will try to fix that error but cannot. See the schematic below. There is one that I followed while the other one is the schematic from Multisim.
What might be the problem? It's a very simple scheme, but maybe there's an error in Multisim? Thanks.
Components values
R1 - 470 Ohm
R2 - 470 Ohm
R3 - 3.9 kOhm
R4 – 3.9 kOhm
P1 - 50 kOhm
C1 – 47 μF / 16V
C2 - 47 μF / 16V
T1 - BC 547 B
T2 - BC 547 B
D1 - LED Standard , 5 mm , red
D2 - LED Standard , 5 mm , red
Attachments
Last edited: