Matthew Amiri
New Member
Hi
I have a small transformer sitting on my desk. It came from a Frigidaire oven PCB that set temps and controls the operation,
size is 34 x 34 x 32 mm excluding the 5mm length of the pins at the bases. Takes in 120VAC - output is not known.
The unit was damaged during a power surge, damaging the primary winding. There are three (3) pins on the Primary winding and four (4) pins on the Secondary winding.
Markings on it are:
LEI-4 0306
E154515
B-2
Class 130 (B)
LS-A7632-PT
Mod. NO.: 35DOBOP-004
The primary winding is burned up (power-surge) - I can not measure and don't know the Primary Resistance.
I have not measured the secondary resistance, but I would assume I could, if needed,..
Any ideas WHERE I can buy a replacement unit??
Any recommendation is appreciated,... Thanks
I have a small transformer sitting on my desk. It came from a Frigidaire oven PCB that set temps and controls the operation,
size is 34 x 34 x 32 mm excluding the 5mm length of the pins at the bases. Takes in 120VAC - output is not known.
The unit was damaged during a power surge, damaging the primary winding. There are three (3) pins on the Primary winding and four (4) pins on the Secondary winding.
Markings on it are:
LEI-4 0306
E154515
B-2
Class 130 (B)
LS-A7632-PT
Mod. NO.: 35DOBOP-004
The primary winding is burned up (power-surge) - I can not measure and don't know the Primary Resistance.
I have not measured the secondary resistance, but I would assume I could, if needed,..
Any ideas WHERE I can buy a replacement unit??
Any recommendation is appreciated,... Thanks