Found this and noticed when the 12V system is not being charged because output is too low you can have some lower voltage batteries attached and charging so the low output is not lost
Could be adapted to charge a large LiPo say which then is used to recharge iPods and phones etc
I don't like the top voltage limit .It should never be higher than 14.3 Volts in my opinion as if your battery reaches this voltage it is gassing and heating and doing damage. So if anyone has any suggestions to alter that part please post it here.
Could be adapted to charge a large LiPo say which then is used to recharge iPods and phones etc
I don't like the top voltage limit .It should never be higher than 14.3 Volts in my opinion as if your battery reaches this voltage it is gassing and heating and doing damage. So if anyone has any suggestions to alter that part please post it here.
Attachments
Last edited: