Why factory RESET comes during memory bootloading ? HW or SW issue ?

Status
Not open for further replies.
Hi there,

I am working a WIFI module as follows,
https://www.semiconductorstore.com/cart/pc/viewPrd.asp?idproduct=73461&utm_source=octopart&utm_medium=compref&utm_campaign=OCTPTEC&utm_term=FCM9000SC-100

To activate it, need to download 4 image file like Serial Flash Discoverable Parameter coverage.
At the same time I am using a USB to Serial COM port works in 5volt.

But, wifi module accepts 3.3v, so I am using TX, RX from USB Serial COM which has 3.3 level also.
To maintain 3.3 v for WIFI, an external power supply has used.

Not sure, after downloading why factory reset command appears ?
For voltage swing ?

In Serial terminal error massage says,

SETUP: ERROR(ret=9)

All services have been stopped.
Please reboot or setup again.

[PRADA:NVRAM] reboot

ERROR
PTIM is relocated to RETMEM (00184110)
RaLIB is relocated to RETMEM (00180810)

 
Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…