Cyclenorthman
New Member
Hi Folks,
I have just started a repair service for a consumer product and am looking for a solder rework station that might speed up repairs.Right now it is desoldering braid,cut ic leads from the ic body and remove each pin and clean out the pin holes.
I would like some feedback from you as what you use.I was thinking about a hot air type system for DIP work and could use some feedback if any of you have used this type of system or what work best for you?
Thanks for your feedback,
CNM
I have just started a repair service for a consumer product and am looking for a solder rework station that might speed up repairs.Right now it is desoldering braid,cut ic leads from the ic body and remove each pin and clean out the pin holes.
I would like some feedback from you as what you use.I was thinking about a hot air type system for DIP work and could use some feedback if any of you have used this type of system or what work best for you?
Thanks for your feedback,
CNM