just taken deliver of a Unicorn that I wish to use to speed up my debugging on Inchworm
Downloaded and programmed Unicorn.hex (Unicorn 18F4550(2)+BOR) using MPLAB and the serial inchworm, can't get the USB interface to work with
MPLAB V8.40 , usb talks, update doesn't work,
I have tried the second link to ICD2_4550(2) there is one file there that when programmed does nothing and another I can't program.
I have a hunch that MPLAB have written out third party USB programmers in V8.4 - I really don't wish to roll back MPLAB as I'm in the middle of a project.
so I'm back to RS232 Any ideas please, I'm a bit disappointed after a 4 week wait for the Unicorn
CD0021: Unable to connect with MPLAB ICD 2 (USB)
MPLAB ICD 2 ready for next operation
Connecting to MPLAB ICD 2
Updating ICD2 USB FW from version FFFF to 0102. Do not disconnect USB cable.
...Connected ICD0082: Failed MPLAB ICD 2 operation
MPLAB ICD 2 ready for next operation
Can you send me a link the unicorn software you used? the **broken link removed** website has links to two versions one of which doen't appear to work
To use your Unicorn as a Inchworm+ USB upgrade just program it with **broken link removed** You can then attach your Unicorn to the underside of an Inchworm+ (like the illustration on the bottom of this page).
And this is the Inchworm+ mounted directly to the Unicorn, the pair appear in MPLAB as a MPLAB firmware client. You have to program the 18F4550 with a special **broken link removed**first. 12mm spacers are ideal
I had used my Unicorn for something else and so downloaded the hex file from Bills (blueroom) site. It is the one called, Unicorn 18F4550 +BOR.hex. I programmed it with the stand alone PK2 programmer. However, if windows recognizes it then it should work.
Pommie, so you downloaded MPLAB , programmed your unicorn with a stand alone programmer using the same software. Did you get similar messages - without the errors to the ones I posted?
I have another PC with MPLAB, will try that, suspect I may need a clean install of MPLAB