trying to figure out what the output of this part will be

Status
Not open for further replies.
B

beanboi

New Member
So i happened to get ahold of a gbu605 and a few diodes, a transformer, and some capacitors,
i dont have a voltmeter or anything and i wanna make a phone charger just because. my idea is that supposedly the gbu is a 600v 6a bridge rectifier. its a stupid idea but if i hooked 120v 60hz ac into the ac part what would be my output in dc?
how could i build a circuit for this
 
"Rough" DC, peaking at around 1.4 x the nominal AC voltage.
(The AC is given as RMS, not peak).



You need a transformer from 120V down to around 8 - 9V, then rectify and regulate that.
 
i found this mystery transformer with digits on it but i cant identify this specific one. it appears to have a us mains cable on one end and two smaller wires from the secondary each have 300v capacity idk what is comes to tho
the digits are DB-EI28-6836A
 
It sounds like you're about to blow something up. I'd stop now if I was you.

Mike.
 
beanboi said:
i found this mystery transformer with digits on it but i cant identify this specific one. it appears to have a us mains cable on one end and two smaller wires from the secondary each have 300v
Click to expand...
That sounds lethal. Don't use it if you have no meter for checking its parameters.
 
Status
Not open for further replies.

Similar threads

  • Question
Can the amperage of this power supply module be modified to increase?
Replies
11
Views
927
xmanhattan
X
C
  • Question
Trying to identify a component
Replies
4
Views
2K
Diver300
D
Y
  • Question
What is this?
Replies
4
Views
767
Tony Stewart
  • Question
What is the waveform and frequency of the lcr t4 device when testing the capacitor?
Replies
7
Views
622
danadak
  • Question
What is the maximum temperature of a lithium battery when overloaded?
Replies
4
Views
630
rjenkinsgb
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…