tansis
New Member
This arrived via PM earlier
Hmm, well Wee Yang the "voice direct module" is not directly compatible with I2C or any other serial format. An interface could be implemented by hardware using a PIC converting parrallel info to the data that can be read either by the I2C bus or the infra-red board input that it used by the "GP2 Brain Stem Module".
If you are are using a remote computer to control the robot via the RF link then the voice module might be connected to the parrallel port then the problem is merely writing the software .
Hmm, well Wee Yang the "voice direct module" is not directly compatible with I2C or any other serial format. An interface could be implemented by hardware using a PIC converting parrallel info to the data that can be read either by the I2C bus or the infra-red board input that it used by the "GP2 Brain Stem Module".
If you are are using a remote computer to control the robot via the RF link then the voice module might be connected to the parrallel port then the problem is merely writing the software .