Hi all,
Just a quick question about the AC Rating on Stripboard.
I have a 12VAC 10A powersupply that powers 2 door locks.
Each door lock is rated at 3A.
So, worst case scenario is when both door locks are activated at the same time.
I want to create a supply distribution board for this, as my current setup is a bit messy.
I want to know if standard stripboard will be able to handle this on a single line.
Will soldering over the holes help?
Maybe do double line for V+ and GND??
Thanks
Just a quick question about the AC Rating on Stripboard.
I have a 12VAC 10A powersupply that powers 2 door locks.
Each door lock is rated at 3A.
So, worst case scenario is when both door locks are activated at the same time.
I want to create a supply distribution board for this, as my current setup is a bit messy.
I want to know if standard stripboard will be able to handle this on a single line.
Will soldering over the holes help?
Maybe do double line for V+ and GND??
Thanks