I built a small stereo and mic mixer that used to work until I changed the output connector from mono to stereo so I didn't have to use an adapter on the cable to connect the mixer to the amplifier's aux. input.
In the attached schematic what is highlighted in yellow are the parts I added and the line in red is what I took out.
I would really appreciated if any one could point me to my error. I am perplexed.
Thanks,
mech3d
In the attached schematic what is highlighted in yellow are the parts I added and the line in red is what I took out.
I would really appreciated if any one could point me to my error. I am perplexed.
Thanks,
mech3d