tiltawhirl
New Member
Hi all,
Been reading through the various threads but have yet to find something quite in line with my current questions. I hope someone can at least point me in the right direction. My electrical/electronics knowledge is limited to 'enough to be dangerous' but I do have a good handle on soldering and other basics of circuit design.
My question relates to taking 110ac voltage from the wall to run a 90v ac motor. Speed control is not that important, however reversing direction is a must. If it is possible to vary the speed, all the better.
What I am trying to wire is a 12" linear actuator which will be used as a lifting arm for one of my current models.
**broken link removed**
As you can see in the image, there is a black, white, and green, along with a brown and red which are spliced from the black and white that lead to the capacitors. I am assuming the brown goes onto the cap board(and has just come unsoldered) but I have no idea what to do from there.
**broken link removed**
Anyone want to give a little coaching on how to wire this thing for forward and reverse without killing myself?
Thanks in advance!
tilt
Been reading through the various threads but have yet to find something quite in line with my current questions. I hope someone can at least point me in the right direction. My electrical/electronics knowledge is limited to 'enough to be dangerous' but I do have a good handle on soldering and other basics of circuit design.
My question relates to taking 110ac voltage from the wall to run a 90v ac motor. Speed control is not that important, however reversing direction is a must. If it is possible to vary the speed, all the better.
What I am trying to wire is a 12" linear actuator which will be used as a lifting arm for one of my current models.
**broken link removed**
As you can see in the image, there is a black, white, and green, along with a brown and red which are spliced from the black and white that lead to the capacitors. I am assuming the brown goes onto the cap board(and has just come unsoldered) but I have no idea what to do from there.
**broken link removed**
Anyone want to give a little coaching on how to wire this thing for forward and reverse without killing myself?
Thanks in advance!
tilt