Hello folks,
I want to build a RF controller using Op-Amp or transistor with minimum components,
a remote which switches current on receiver side
if you have any schematics then please give me here.
it is for my own learning.
Thankyou
minimum component count for the sort of thing you require TX and RX is probably getting up to ~ 50 or so if using discrete components.
you would at least cut that in half if you used some of the various RF TX and RX modules available
Hello folks,
I want to build a RF controller using Op-Amp or transistor with minimum components,
a remote which switches current on receiver side
if you have any schematics then please give me here.
it is for my own learning.
Thankyou
You may need some additional coding on the transmitter as 433MHz is a very busy channel and in the UK is very close to TETRA.
You cannot simply rely on signal strength.
minimum component count for the sort of thing you require TX and RX is probably getting up to ~ 50 or so if using discrete components.
you would at least cut that in half if you used some of the various RF TX and RX modules available
i want discreet component one, as i said i want to study it.
I want both TX and RX with frequency of operation upto 1 MHz
voltage of operation is from 3 to 9V , i have no idea how much range i would get from these source.
modulation method can be both AM/FM depends which is simple
There are many circuits on the web for transmitters and receivers. Just Google for them. Bear in mind that in most countries transmitting without a licence, except at certain frequencies and powers, is illegal.