screw terminal block for solderless breadboard

[g2c]

Hello, can someone recommend terminal blocks like these ones but with long enough legs for a solderless board? Thanks!

 

[rjenkinsgb]

None exist, as far as I am aware - they would have no use in commercial manufacturing.

You can easily get terminal adapters for breadboards, just a small PCB with both standard terminals and header pins to suit the breadboard.
**broken link removed**

Or you could make you own, with bits of stripboard & add terminals and pins.

Converting a 2.54mm pitch header to screw terminal blocks

I'm trying to avoid soldering or modding of any kind as I'm 7,000 miles away from where the project is based! I'm trying to come up with a simple solution I can get a layman to do on my behalf. I h...

electronics.stackexchange.com

 

[gophert]

TBL003-254-02GR-2OR CUI Devices | Connectors, Interconnects | DigiKey

Order today, ships today. TBL003-254-02GR-2OR – 2 Position Wire to Board Terminal Block Horizontal with Board 0.100" (2.54mm) Through Hole from CUI Devices. Pricing and Availability on millions of electronic components from Digi-Key Electronics.

www.digikey.com

https://media.digikey.com/Photos/TE%20Connectivity/282834-2.JPG

Terminal Blocks - Wire to Board | Electronic Components Distributor DigiKey

Terminal Blocks - Wire to Board are in stock at DigiKey. Order Now! Connectors, Interconnects ship same day

www.digikey.com

 

[rjenkinsgb]

???
All those are standard solder pin PCB terminals, not ones intended to plug directly in to a solderless breadboard, or capable of being used like that.

 

[g2c]

???
All those are standard solder pin PCB terminals, not ones intended to plug directly in to a solderless breadboard, or capable of being used like that.

indeed, legs are <= 3..5 mm: too short for solderless board

 

[KeepItSimpleStupid]

Just solder these https://www.digikey.com/en/products/detail/amphenol-fci/20021111-00010T4LF/2209072 to standard -0.1" screw terminals.

Generally, they can be cut. Use two row for stability.

 

[gophert]

Just solder these https://www.digikey.com/en/products/detail/amphenol-fci/20021111-00010T4LF/2209072 to standard -0.1" screw terminals.

Generally, they can be cut. Use two row for stability.

Good idea but the exact headers in your image are 0.05inch. Did you make a selection mistake or do you pull out every other pin?

 

[KeepItSimpleStupid]

I have unimaginable migraine. Help him figure it out.

 

[KeepItSimpleStupid]

So, these https://www.mouser.com/ProductDetail/Samtec/TSW-105-07-G-D could work for 10 position.