I agree. There is a similar problem in the board editor. Most people who learn the system via trial and error will stumble into these things. It is best to start with a tutorial.
Thanks 3V0, you da man Now if i can just figure out the purpose of that wire cmd. The help explains it as: Function
Adds wires (tracks) to a drawing.
Well that explains it...
Thanks 3V0, you da man Now if i can just figure out the purpose of that wire cmd. The help explains it as: Function
Adds wires (tracks) to a drawing.
Well that explains it...
I suggest you ignore it. Both in the schematic editor and in the board editor. Use the net command to draw wires on the schematic and route to places the traces in the board layout.