ikalogic
Member
Hello,
I am starting to build a data link between a 8051 or/and AVR micro controller and the PC through the serial port. I am using USB to SERIAL cables to provide a serial PORT to my LAPTOP.
I'll start with the 8051 (89S52 micro controller)
I'll be using Visual Basic's MSCOMM control to control the communication.
I have all the components ready to be assembled, but before i start i have a little question: Do i have to stick with the 9600 Baud rate?
I am using a 24Mhz crystal, and the baud rate is hence 375000 from the micro controller side. In Visual basic, do i simply enter 375000 in the baud rate field? Or are there certain values that i have to stick to?
Thanks for the help
I am starting to build a data link between a 8051 or/and AVR micro controller and the PC through the serial port. I am using USB to SERIAL cables to provide a serial PORT to my LAPTOP.
I'll start with the 8051 (89S52 micro controller)
I'll be using Visual Basic's MSCOMM control to control the communication.
I have all the components ready to be assembled, but before i start i have a little question: Do i have to stick with the 9600 Baud rate?
I am using a 24Mhz crystal, and the baud rate is hence 375000 from the micro controller side. In Visual basic, do i simply enter 375000 in the baud rate field? Or are there certain values that i have to stick to?
Thanks for the help