I’m using reverse current protection as in figure d but without the capacitor, it works well.
**broken link removed**
but I am concern if the input voltage is say 60V then the Vgs is -60 and the datasheet Vgs=+-20V
I’m using a p-mosfet (PMOS_BSS84) and the resistor of 1 M to GND.
Is it OK or I need a protection for the gate source voltage to not exceed 20volts.
**broken link removed**
but I am concern if the input voltage is say 60V then the Vgs is -60 and the datasheet Vgs=+-20V
I’m using a p-mosfet (PMOS_BSS84) and the resistor of 1 M to GND.
Is it OK or I need a protection for the gate source voltage to not exceed 20volts.