StudentSA
Member
Hi,
I do not have a Hot air/Reflow station and I do not make PCBs at all but an IC that I want to use only comes in a 6 pin TDFN package. I have found that a lot of IC`s are not being made in DIP packages anymore.
What is the best way to use this IC? Shall I attempt to solder wires onto the contacts? or do you get a PCB converter that you can plug these things in and have access to solder pads/pins.
Thanks,
StudentSA
I do not have a Hot air/Reflow station and I do not make PCBs at all but an IC that I want to use only comes in a 6 pin TDFN package. I have found that a lot of IC`s are not being made in DIP packages anymore.
What is the best way to use this IC? Shall I attempt to solder wires onto the contacts? or do you get a PCB converter that you can plug these things in and have access to solder pads/pins.
Thanks,
StudentSA
Last edited: