Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

problematic counter....

Status
Not open for further replies.

zanklob

New Member
guys i need your help..

i built a counter and although it works fine on multisim
it doesn't count right in the raster..

i have the circuit down here..

the only changes i made is that i used an 74ls193 instead of a 74ls192
and that in order to the pulse i put in and out a wire..

if someone has a clue please help..because i should have finish the project two weeks ago...
 

Attachments

  • final.doc
    623.6 KB · Views: 463
mike i looked at the datasheets and they are the same...

the raster is the thing i plug in the chips and the wires and the 7segment..
 
guys i need your help..

i built a counter and although it works fine on multisim
it doesn't count right in the raster..

i have the circuit down here..

the only changes i made is that i used an 74ls193 instead of a 74ls192
and that in order to the pulse i put in and out a wire..

if someone has a clue please help..because i should have finish the project two weeks ago...
When you use a switch, or touch a wire to a voltage source, contact bounce will occur, generating several transitions each time. You have to debounce your input. You will also need a pullup or pulldown resistor.
 
Last edited:
this circuit here shows how to debounce a switch(spdt-single pole double throw)to provide clean clock signals using a 4093(2 gates,the switch and two pull up resistors)gates u 1 and u 2 are the set reset latch.........
 

Attachments

  • cctv switcher.jpg
    cctv switcher.jpg
    56 KB · Views: 764
Last edited:
Status
Not open for further replies.

Latest threads

New Articles From Microcontroller Tips

Back
Top