Hi,
I am trying to build a E cigarette mod
but having the voltage problem. The heater do not receive enough voltage to operate and only receive 1.2V-1.6V.
Heater required to receive 3V to operate properly, do you know how to fulfil it?
this is the schematic diagram:
Power source :[/B] Li polymer 1000maH 3.7V battery,
Mosfets: IRLR3114/FDN357N.
- I tried at least 6 mosfet which have low VGS (1-2V), but still can not solve the problem)
Heater: atomizer in ecig
- when it directly connect to power source, it can operate properly and it draw 3.7V and 0.98A
;but add into circuit, it only receive 1.2V-1.6V.
I am trying to build a E cigarette mod
but having the voltage problem. The heater do not receive enough voltage to operate and only receive 1.2V-1.6V.
Heater required to receive 3V to operate properly, do you know how to fulfil it?
this is the schematic diagram:
Power source :[/B] Li polymer 1000maH 3.7V battery,
Mosfets: IRLR3114/FDN357N.
- I tried at least 6 mosfet which have low VGS (1-2V), but still can not solve the problem)
Heater: atomizer in ecig
- when it directly connect to power source, it can operate properly and it draw 3.7V and 0.98A
;but add into circuit, it only receive 1.2V-1.6V.
Attachments
Last edited: