Printer startup bypass??

Status
Not open for further replies.

Makaram

Member
Hey guys,
Trying to turn my printer into a flatbed printer getting stuck on the startup check (you know the one where it goes through all its tests) because of the paper feed sensor (this is a interrupt sensor)
Was wondering if any1 would know how to bypass this startup phase or perhaps overcome this paper feed crap
 

This may go better for help if you define the printer?

Ron
 
Conventional wisdom is that one gets a small micro and emulates the sensor signals its supposed to see.

Generic answer for a generic question.
 
Are you saying you have a bad paper feed sensor? If so either replace it or emulate the correct sensor signal.
 
i think this is the answer im looking for. thanks champ.
But still interested to know if theres a way to completely bypass this
 
Last edited:
Status
Not open for further replies.

Similar threads

  • Question
Triac problem at startup
Replies
3
Views
647
quincisoft
N
  • Question
How to bypass a touch switch on a humidifier?
Replies
14
Views
2K
nicofiaba
N
555 bypass?
Replies
6
Views
2K
Tony Stewart
D
  • Solved
Bypass touch button on fan
2
Replies
28
Views
4K
Danster
D
C
  • Solved
Bypass touch "button"
Replies
11
Views
5K
rjenkinsgb
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…