Thank you a lot for help.
I'm trying as much as possible not to rip off someone else's design but just to borrow some ideas. I borrowed some ideas from your last design also but I'm still experiencing problems. So i tried to simulate your design, and now I'm completely confused. Look at this.
Now either I'm doing something completely wrong or its my software.
I'm using National Instruments Circuit Design Suite 10.0, but so far everything i simulated was quite precise when assembled later with physical parts.
Any idea why am i getting this kind of simulation output?
I'm trying as much as possible not to rip off someone else's design but just to borrow some ideas. I borrowed some ideas from your last design also but I'm still experiencing problems. So i tried to simulate your design, and now I'm completely confused. Look at this.
Now either I'm doing something completely wrong or its my software.
I'm using National Instruments Circuit Design Suite 10.0, but so far everything i simulated was quite precise when assembled later with physical parts.
Any idea why am i getting this kind of simulation output?