Ermir
New Member
Hello everyone.
I'm building a power amplifier but I need some help with that.
Power Supply input +-30V
The PA is supposed to drive a motor and the output of it must be as below:
Output
--------
+-25V
5 A
125 W
I also need a preamplifier so the motor will not have all the 25 volt imediately. On the top of the motor is a heavy load so it has to rotate slowly (ramp) till it reaches the 25 V in 1 sec.
Any idea what to use for the power amplifier?
I was using a HC2000H from RCA but I couldn't find the datasheet for that so I can't use it anymore.
Thanks in advance.
I'm building a power amplifier but I need some help with that.
Power Supply input +-30V
The PA is supposed to drive a motor and the output of it must be as below:
Output
--------
+-25V
5 A
125 W
I also need a preamplifier so the motor will not have all the 25 volt imediately. On the top of the motor is a heavy load so it has to rotate slowly (ramp) till it reaches the 25 V in 1 sec.
Any idea what to use for the power amplifier?
I was using a HC2000H from RCA but I couldn't find the datasheet for that so I can't use it anymore.
Thanks in advance.