Hi. I am very very new at stepper motors.
I am trying to build a robot but i can't figure out how to control the motors.
I have plenty of stepper motors from printers.
I tried to build L297 with L298n but i failed...
I have some questions:
My stepper motor is 27 volts , 6.4 Ohm ; so what Vref i need?
Where do i need to wire control , reset ,home, etc...
Thanks.
I am trying to build a robot but i can't figure out how to control the motors.
I have plenty of stepper motors from printers.
I tried to build L297 with L298n but i failed...
I have some questions:
My stepper motor is 27 volts , 6.4 Ohm ; so what Vref i need?
Where do i need to wire control , reset ,home, etc...
Thanks.