I have a Cut50 cheap chinese plasma cutter .Mostly it works fine but lately the starter fails to ignite it . This happens on say the second start of cut and I leave it for 30 secs or so and it starts again then won't on the next one .
I have checked ,adjusted and played with the contact set spark gap inside the machine but it seems that as long as there is a spark across the contacts that does not affect the gun. Somrthing else is getting hot or not working properly like say a capacitor or component on the fly over transformer .
Does anyone know anything about the start circuit itself or what usually gives trouble . Thanks
I have checked ,adjusted and played with the contact set spark gap inside the machine but it seems that as long as there is a spark across the contacts that does not affect the gun. Somrthing else is getting hot or not working properly like say a capacitor or component on the fly over transformer .
Does anyone know anything about the start circuit itself or what usually gives trouble . Thanks