wuchy143
Member
Perhaps I should go to the Microchip forum for this question but I like electrotech so here it goes...
I'm learning how to program the PIC12F675 in C using The High Tech C Compiler. Scrounging the internet I was able to find the configuration script at the top of the C program which is entered before main(). My question is how do I know what that is for a specific microcontroller? Does it all depend on the given compiler? If it depends on the compiler how do most micro programmers figure that out? I will add I'm slightly a noob to micro programming. Basically how does everyone figure out what the need to put in the configuration script to make the PIC do what you want.
Thanks
-mike
I'm learning how to program the PIC12F675 in C using The High Tech C Compiler. Scrounging the internet I was able to find the configuration script at the top of the C program which is entered before main(). My question is how do I know what that is for a specific microcontroller? Does it all depend on the given compiler? If it depends on the compiler how do most micro programmers figure that out? I will add I'm slightly a noob to micro programming. Basically how does everyone figure out what the need to put in the configuration script to make the PIC do what you want.
Thanks
-mike