Menticol
Active Member
Hello!!
As I posted before, my room sound system consist in:
LG DWE 630 DWE 2.1 home theater to drive front speakers
Car stereo for rear speakers
Others: car EQ, etc.
Nothing big or expensive, but works nice.
The topic is, I got a tube amp, and put it on place of the LG. But I really missed the LG bass, so I started using it with the speakers removed (just the sub-woofer alone).To avoid ruining the amp, I put a 5W 6.8 ohm resistor as phantom load on each speaker output.
The removed speakers are 8 ohm rated. I used 6.8 ohm resistors just because I had them on stock.
Is a good phantom load, or I'm ruining it?
As I posted before, my room sound system consist in:
LG DWE 630 DWE 2.1 home theater to drive front speakers
Car stereo for rear speakers
Others: car EQ, etc.
Nothing big or expensive, but works nice.
The topic is, I got a tube amp, and put it on place of the LG. But I really missed the LG bass, so I started using it with the speakers removed (just the sub-woofer alone).To avoid ruining the amp, I put a 5W 6.8 ohm resistor as phantom load on each speaker output.
The removed speakers are 8 ohm rated. I used 6.8 ohm resistors just because I had them on stock.
Is a good phantom load, or I'm ruining it?
Last edited: