fifahaywire
New Member
i'm using eagle to make my pcb. i'm doing a bridge rectifier (input 240Vac),
a few questions..
-do i need a fuse at the input? but measuring the input current it doesn't go up much.
-what's the proper width for the wire traces? is 0.4mm fine?
-for the input..can i use this connectors? View attachment 63588 or should i use something else?
thanks!
a few questions..
-do i need a fuse at the input? but measuring the input current it doesn't go up much.
-what's the proper width for the wire traces? is 0.4mm fine?
-for the input..can i use this connectors? View attachment 63588 or should i use something else?
thanks!