Ozipic'er p16pro40 problem

Well I toggleled the pins high/low on/off but voltage never changed, always stays the same.

2 = 5.87V
4 = 5.86V
5 = 0.76V
8 = 5.9V
10 = 0.77V
12 = 0.768V
 
I have changed a faulty component on the board and now the LEDs switch on/off according to WinPicProg, but it still doesn't detect it. I tried to program it but the program gives me an error after verifying.
 
Last edited:
The auto-detect works like this:

1) Select the first port address.

2) Set Vdd ON

3) Toggle Data (D0) up and down.

3) Check for the same returned data on the Ack pin.

4) Select second possible address and do the test again.

You can easily do this manually, and check that the Ack line changes with Data out (it's even indicated on the WinPicProg manual toggling screen).
 
I tried with my windows 98 old pc and it didn't detect it, but with my windows 7 (5 year old pc) detected it but didn't program correctly, with another pc (win xp) it didn't detect it with winpicprog but programmed it with icprog.
 
I don't know I downloaded Icprog NT/2000 driver file, launched icprog and it programmed it without problem.
 
You must log in or register to reply here.

Similar threads

Y
  • Question Question
Regarding the Proteus8 software simulation problem, how to generally solve this problem?
Replies
2
Views
3K
Tony Stewart
E
  • Question Question
Problem in Running SX1281 Semtech lora IC with Stm32 UART protocol
Replies
1
Views
3K
ahsrabrifat
A
W
  • Question Question
C18 problem
Replies
10
Views
5K
Nigel Goodwin
O
  • Question Question
ESP32-CAM problem after uploading
Replies
5
Views
5K
ZipZapOuch
T
  • Question Question
Closed-loop stepper motor control problem
Replies
1
Views
2K
rjenkinsgb
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…