ESP32-CAM problem after uploading

[okbro]

hello,

After successfully uploading code and removing the FTDI programmer, and applying external regulated 5V to the ESP32 CAM, when i try to connect to the given server at 192.168....., the server does not work showing problem loading page...there is nothing. how to solve?

 

[danadak]

Router rejecting connection ? login to your router to see status.

Firewall allowing video stream enabled ?

Regards, Dana.

 

[ZipZapOuch]

hello,

After successfully uploading code and removing the FTDI programmer, and applying external regulated 5V to the ESP32 CAM, when i try to connect to the given server at 192.168....., the server does not work showing problem loading page...there is nothing. how to solve?

These things ESPCAM modules need a lot more power and doesn't like ripple. You need a 1Amp 3.3v power supply with at least 100uF cap. Note that most ESPCam modules are not 5v compatible.

 

[okbro]

the router DHCP list shows that the ESP32 CAM has the same valid IP address but the page is showing nothing, (problem loading page), any further advice?

 

[okbro]

These things ESPCAM modules need a lot more power and doesn't like ripple. You need a 1Amp 3.3v power supply with at least 100uF cap. Note that most ESPCam modules are not 5v compatible.

i will try better power supply and post the result

 

[ZipZapOuch]

i will try better power supply and post the result

They connect to the LAN and then reset themselves when they brownout as the camera starts.