codan
New Member
Hi all,
I have a metal detector that i want to test the output to the coil.
There is a circular 5 pin plug that the search coil plugs into, the pins are numbered 1 through 5 in an anticlockwise direction.
I would like to determine which pins are the output voltage pins to the search coil etc, the detector is a Minelab GP3500.
Is this as straight forward as just making contact with the pins with a multimeter, can any damage occur by doing this??
Thank You
I have a metal detector that i want to test the output to the coil.
There is a circular 5 pin plug that the search coil plugs into, the pins are numbered 1 through 5 in an anticlockwise direction.
I would like to determine which pins are the output voltage pins to the search coil etc, the detector is a Minelab GP3500.
Is this as straight forward as just making contact with the pins with a multimeter, can any damage occur by doing this??
Thank You