Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
I'm using this circuit with my PT100 Sensor it worked nicely 1 month continuously without any problem,after now its not working,it wont amplify the signal always output is 0.
Your input voltage is shown as "12v". Is that correct? Because that is the absolute min requirement for the 7810 regulator you also show.
Your circuit probably doesnt need that 7810 regulator as you can connect the LM358 positive supply terminal right to the +12v.
The 12v could be a problem if it drops any lower than that. Really the min should be 12.5 volts.
This is just one possible reason the circuit stopped working.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.