NiranjanCD
New Member
Hi,
I was new to the forum and i found most of the discussion for the nRF module is going in these forum.I am using the nRF24l01+ module with the TM4C123G microcontroller and configuration is done as per the given information in the datasheet of the both the sensor and controller. Tx and Rx is working fine when no ACK condition but heavy data loss is there upto 20% and another thing if i gave a manual ACK command (W_ACK_PAYLOAD) in the RX side to the TX it was also not working. So,can any help me to solve these issue and provide me some tips to reduce the payload loss.
Regards
Niranjan.C.D
I was new to the forum and i found most of the discussion for the nRF module is going in these forum.I am using the nRF24l01+ module with the TM4C123G microcontroller and configuration is done as per the given information in the datasheet of the both the sensor and controller. Tx and Rx is working fine when no ACK condition but heavy data loss is there upto 20% and another thing if i gave a manual ACK command (W_ACK_PAYLOAD) in the RX side to the TX it was also not working. So,can any help me to solve these issue and provide me some tips to reduce the payload loss.
Regards
Niranjan.C.D