dcwatson84
Member
I bought the following SPST dual coil latching relay and breadboard...
**broken link removed**
**broken link removed**
I'm trying to lay it out on a breadboard, and Im trying to get the orientation correct to allow me to control the latching relay.
If I lay the relay across the middle ravine horizontally (long-ways), the switched pins seem to be shorted because they are on the same horizontal row.
If I lay it vertically on one size of the board, the controlling pins are all shorted because they are on the same horizontal row.
I assume Im either missing something or bought incompatible components. Hopefully there's a pretty simple answer, any help is appreciated!
**broken link removed**
**broken link removed**
I'm trying to lay it out on a breadboard, and Im trying to get the orientation correct to allow me to control the latching relay.
If I lay the relay across the middle ravine horizontally (long-ways), the switched pins seem to be shorted because they are on the same horizontal row.
If I lay it vertically on one size of the board, the controlling pins are all shorted because they are on the same horizontal row.
I assume Im either missing something or bought incompatible components. Hopefully there's a pretty simple answer, any help is appreciated!