skeeterb
Member
I'm going to try to use an atmel ATTINY24 for a small circuit to make an automatic transmission for a '90 Grand Am into something like a manumatic. I've looked at the circuit diagram for the 1990 Grand Am with a 2.3L engine and there are like 4 wires going to the transmission from the PCM. I am going to ask more about the transmission on the Grand Am Forum, so I can get more information than is in the Chilton's and Haynes repair manuals. I've downloaded the datasheet for the chip and downloaded the version of Flowcode for AVR chips. My question is how would one go about setting the configuration bits on the ATTINY24? The PIC configuration is pretty user friendly but there isn't as much friendliness to the Flowcode Configuration for the Atmel chips.